|
KSE TS 880
Transfer Switches- Service Entrance / KSE TS 880
 
- Service entrance automatic transfer switches incorporate an isolating mechanism and overcurrent protection on the utility supply thereby removing the need to have a separate, upstream circuit breaker/disconnect switch from the transfer switch.
- Standard features of the service entrance rated automatic transfer switch include a NEMA 1 rated enclosure, padlockable service disconnect control switch and status indications.
- TS 880 service entrance automatic transfer switches are specifically designed and certified to the UL 1008 standard as well as complying with NEC and NFPA requirements.
- All TS 880 service entrance transfer switch models have been 3-cycle withstand current tested in accordance with UL 1008 and CSA 178, which allow high current ratings and use of non-series rated upstream protective devices. The TS 880 service entrance automatic transfer swich is rated for the system load and requires upstream overcurrent protection on the generator supply.
- The TS 880 service entrance transfer switches use a type TSC 800 microprocessor-based controller.
- Load on utility and load on generator lights with lamp test
- Three-phase voltage sensing on utility and generator sources
- Under/overfrequency sensor on the generator source (with adjustable time delay)
- Under/overfrequency sensor on the utility source (with adjustable time delay)
- Overvoltage 3-phase sensor on both utility and generator sources
- Digital 3-phase metering of voltage and frequency on the utility and generator sources
- Exercise timer, 7-, 14-, 21-, or 28-day
- Data logging
Category: Transfer Switches- Service Entrance / KSE TS 880 |
|
|
|
Spec. Sheet - g11104.pdf 264 Kb
